The set-up procedure for a V1 Coiltek loop-control system is quick and easy.
Please pay close attention to either the written instructions below or those
given in the video to insure your unit is set up properly. If you find that your
unit fails to calibrate even after following this procedure, please contact us
immediately at (800) 883-7542 or using the form on the Contact Us page.
The new set-up procedure for the CS-5000 and CS-5100 V2 with the
new CB-5501M is easier than ever. Follow the simple steps listed
below to set your unit up. This procedure works for the new line of
CS-6200 controls as well.
Even more detailed set-up instructions, including a step-by-step 3CPO
programming demonstration, see the videos below.
For older, V1 units (any unit shipped before mid-summer 2013),
please refer to the set-up proceedure video and instructions toward
the bottom of the page.